temperature programming

The influences of temperature programming and the way to add lipase on the contents of monoglycerides ( MG) in reaction mixtures were investigated.

考察了反应温度程序以及加酶方式对最终产物中单甘酯质量分数的影响。

The Research of Temperature Programming Group Controller with Double-microcomputer

Ⅰ组只饲喂基础日粮；双微机温度程序群控仪的研制

A method for the determination of dimethyl carbonate ( DMC) by GC was set up using OV-1 capillary column, hydrogen flame ionization detector ( FID) and two step temperature programming.

选用OV-1毛细管色谱柱及氢火焰离子化检测器（FID），采用二阶程序升温，建立了测定碳酸二甲酯（DMC）含量的气相色谱法。

The capillary column was HP-50 ( 30m × 0.32mm × 0.25 μ m), temperature programming, electron capture detector ( ECD).

采用HP-50毛细管柱（30m×0.32mm×0.25μm），程序升温，电子捕获检测器。

The auther fully considered its' basic nutrition characteristics, photonasty and sensitivity for temperature which determined the parameters for the model, using the method of unconstrained conditions of nonlinear programming step-length accelerated.

模型中充分考虑超级杂交稻的基本营养生长性、感光性与感温性，采用无约束条件下非线性规划的步长加速法确定模型参数。

Molybdenum carbide was prepared with n-hexane as carbon source by temperature programming method.

采用程序升温法，以正己烷为碳化原料制备碳化钼，对噻吩加氢脱硫活性进行了评价。

The mixture of KNO3/ KOH is used as alkali-fusion agent, the reactants are calcinated in a temperature programming from room-temperature to 650 ℃ and kept for 3 h, the melts were leached by boiled water;

KNO3/KOH作碱熔剂，程序升温至650℃，并恒温3h，然后沸水浸渍；

The initial temperatures of the two columns were set at 80 ℃ and 85 ℃ respectively and then increased with temperature programming.

采用程序升温方式，初始温度分别为80℃和85℃。

Optimized Linear Temperature Programming for Capillary Gas Chromatography by the Method of Gridding Search

网格搜索法优化毛细管气相色谱线性程序升温

Meanwhile, a new method of calculating calcination rate coefficient from the data obtained in inert atmosphere and temperature programming was proposed.

本文还提出了从惰性气氛下程序升温数据计算硫酸钙煅烧反应速率常数的方法。

A temperature programming gas chromatography ( GC) was developed for the determination of volatile fatty acids in rumen liquor.

建立了程序升温气相色谱法测定羊瘤胃液中的挥发性脂肪酸。

A Software for Simulation of the Process in Gas Chromatography Column and Optimization of Multi-Step Temperature Programming

气相色谱柱内过程模拟和条件优化软件

Laser Raman spectroscopy and temperature programming reduction study of supported tungsten oxide

负载氧化钨催化剂的拉曼光谱和程序升温还原研究

With this system, natural gas and regenerator flue gas from catalytic cracking unit can be analyzed within 12 minutes with temperature programming above room temperature.

在室温以上程序升温，直接分析天然气及催化裂化再生气，12分钟内可完成全分析。

Results The 11 kinds of organic phosphorus have been well separated in the HP-5 capillary column ( 30 m × 0.32mm × 0.25 μ m), when temperature programming was used.

结果采用程序升温，所测定的11种有机磷在HP-5（30m×0.32mm×0.25μm）毛细管柱上得到很好的分离。

We made the configuration by SCX programming and FBD programming for the system. During the process, fuzzy control and PID control are used to make sure the precision of temperature control is up to the standard.

本论文在进行系统组态时，通过FBD图形编程和SCX语言编程，将模糊控制与PID控制相结合，使得生产过程中的温度控制精度符合要求。

The temperature model of the waved-edge has been constructed according to Jaeger's theory of moving solid under the used temperature model of the flat insert, it is possible to forecast milling temperature through programming.

在已有的平前刀面铣刀片铣削温度数学模型的基础上，利用Jaeger的移动面热源理论，建立了波形刃铣刀片铣削温度的数学模型，编制了计算机程序对铣削温度进行了预测；

Software system adopt the VC programming language, include document preserved and transferred 、 temperature data collect 、 assemble state judging 、 assemble quality judging 、 coordinate adjusted and help.

软件系统采用VC编程语言编写，主要包括：具有文件保存和调用功能的数据库模块、温度数据采集系统模块、安装状态判断模块、安装质量判断模块、坐标调整模块及帮助模块。

Using SPB 1 capillary column with temperature programming, methyl-and ethyl-mercuries hydrides can be base-line separated within 4 min.

使用SPB－1毛细管柱在4min内可基线分离氢化甲基汞和氢化乙基汞。

Calculation of Isothermal Retention Indices from Temperature Programming Data

由气相色谱程序升温数据计算恒温保留指数

These coefficients and the experimental relationships are important to the understanding on the TC of the geotechnical materials in north China and to the temperature simulation programming as well.

该系数和这些经验公式的导出对中国北方地区岩土材料导热性能的理解及温度场模拟工作均具重要意义。

The method of calculating the adiabatic saturated temperature by programming is given and the research shows that the adiabatic saturated temperature is the lowest temperature that makes the air saturated by spraying cooling system.

分析了喷雾冷却的理论过程，指出绝热饱和温度是喷水使空气达到饱和湿空气状态的最低温度，并给出了编程计算绝热饱和温度的方法。

The column temperature was increased by programming with the sample entrance and detector being at250 ℃. The carrier gas was nitrogen. The flow rate was1ml/ min and shunting ratio was25 ∶ 1.N-octyl alcohol was used as internal standard.

方法色谱柱为DB-WAX毛细管柱，柱温采取程序升温，进样口及检测器温度为250℃，载气为氮气，流速为1ml/min，分流比为25∶1，内标为正辛醇。

The cure kinetics of DGEBA/ Dicyandiamide ( DICY) system was investigated under temperature programming curing condition. Differential Scanning Calorimetry ( DSC) was the thermo-analytical technique used to determine the cure kinetics of this system.

采用程序升温差示扫描量热仪（DSC）法研究了DGEBA／双氰胺（DICY）体系的非等温固化反应动力学。

The capillary column was HP-50 ( 30 m × 0.32 mm ×0.25μ m ), temperature programming, electron capture detector ( ECD ).

采用HP-50毛细管柱 ( 30m×0.32mm×0.25μm ), 程序升温, 电子捕获检测器.

Effect of Error in Temperature Programming Desorption Temperature Measurement on Desorption Kinetic Parameters Calculation

程序升温脱附测温误差对脱附动力学参数的影响规律